Suma,M N; Sreedevi, Menon K; Bijumon, P V; Sebastian,M T; Mohanan, P(Microwave and Optical Technology Letters, April 20, 2005)
[+]
[-]
Abstract:
In this paper, we present an effective excitation of a reelangular
dielectric resonator antennas (DRA) with a conductor-hacked
coplanar waveguide (CB-CPW). The radiation and resonance characteristics
are found to van,, depending on the orientation of the DR on
doe coplanar feed line. The effect of finite and infinite ground planes of
CB-CPIV on the radiation characteristics of the rectangular DRA is
studied. The orientation and position of the DR are optimized for maximum
gain and bandwidth. The optimized antenna ,geometry offers
--10.46 dBi gain and 7.5% bandwidth with low cross-polar radiation
characteristics
Paulson,M; Sona,Kundukulam O; Aanandan,C K; Mohanan, P(Department of Electronics, September , 2001)
[+]
[-]
Abstract:
The arrow shaped microstrip antenna, which produces
dual frequency dual polarisation operation with considera-ble size reduction compared to conventional patches has been
reported [I]. These antennas provide greater area reduction and
improved gain compared to drum shaped patches [2]. Prediction
of the resonance frequency of drum shaped patches [3] and circular
patches for broadband operation [4] are available in the literature.
In this Letter, we propose empirical formulas for calculating
the resonance frequencies of the arrow shaped microstrip antenna.
These antennas can be employed for obtaining dual frequency
with the same polarisation, bandwidth enhancement, circular
polarisation etc. by varying its different parameters or by introducing
slots. The proposed design equations provide an easier and
simple way of predicting the resonant frequencies of these patches.
A simple technique for calculating the resonance frequencies of a
compact arrow-shaped microstrip antenna is presented and discussed . The accuracy of the method is validated by experimental results
Sona,Kundukulam O; Paulson,M; Aanandan,C K; Mohanan, P; K G Nair(Department of Electronics, October , 2002)
[+]
[-]
Abstract:
A dual-port microstrip antenna with a crescent shaped
patch with excellent isolation betwecn the ports has been reportcd [I].
Since circular-sided geometries are inore compact than rectangular
oncs, thcy find morc applications in microstrip arrays. The crcscent
shaped antenna geometry [ I ] provides greater area rcductioii compared
to other circular sided patches for broadband operation [2]. In this
Lctter, formulac for calculating thc TM, I and TMZI mode resonant
frequencies of this microstrip antenna, obtained by modifying the
equations of a standard circular patch [3] are presentcd. Thcorctical
results are compared with experimental observations aid the validity
of the computation is established.
Biju Kumar, S; Raveendranath, U; Mohanan, P; Mathew, K T; Hajian,M; Ligthart, L P(Microwave and Optical Technology Letters, July 20, 2000)
[+]
[-]
Abstract:
A simple and efficient method for determining the complex
permittivity of dielectric materials from both reflected and transmitted signals is presented. It is also novel because the technique is implemented using two pyramidal horns without any focusing mechanisms. The dielectric constant of a noninteractive and distributive (NID) mixture of dielectrics is also determined
Vermeeren,G; Rogier,H; Olyslager,F; Zutter De,D(IEE Electronics letters,UK, September 13, 2001)
[+]
[-]
Abstract:
A single-feed rectangular-ring microstrip antenna is proposed for
indoor communication under the Bluetooth protocol. The
dimensions of the antenna together with the location of the feed
point are optimized through field simulations in order to cover the
Bluetooth bandwidth and to avoid linear polarization. The
performance and the efficiency of the antenna are illustrated in a
real indoor environment
Hsieh,Gui-Bin; Chen,Ming-Huang; Wong,Kin-Lu Wong(IEE Electronics letters,UK, June 21, 2001)
[+]
[-]
Abstract:
A novel technique for obtaining dual-hand circular polarization
(CP) radiation of a single-feed circular microstrip antenna in
proposed and demonstrated. By embedding two pain of arc shaped
slots of proper lengths close to the boundary of a circular
patch, and protruding one of the arc-shaped slots with a narrow
slit, the circular microstrip antenna can perform dual-hand CP
radiation using a single probe feed. Details of the antenna design
Binoy,G S; Aanandan,C K; Mohanan, P; Vasudevan, K(Microwave Engineering Group,Department of Electronics, January 5, 2002)
[+]
[-]
Abstract:
A novel dual frequency design of a square microstrip antenna coaxially
fed along the diagonal with a chip capacitor mounted at the bottom of
the stub is introduced. This design provides enhanced area reduction and
good cross-polarization levels. The antenna design can be used as a compact
antenna system where limited size is a major requirement. The details of the
antenna design and experimental results are presented
Sona,Kundukulam O; Manju,Paulson; Aanandan,C K; Mohanan, P(Microwave and Optical Technology Letters, December 5, 2001)
[+]
[-]
Abstract:
Dual frequency operation is achieved from a compact
microstrip antenna by loading a pair of narrow slots close to its radiating
edges. The two frequencies have parallel polarization planes and similar
radiation characteristics. The ratio between the two operating frequencies
can be tuned in the range (1.14-1. 24), which is much smaller than that
of similar designs. The above excellent radiation characteristics are
achieved along with an area reduction of - 75% compared to the
standard rectangular patch
Jianlang,Li; Liren,Liu; Yingchun,Guo; Huaisheng,Wang; Changhe,Zhou(Microwave and Optical Technology Letters, December 20, 1999)
[+]
[-]
Abstract:
The transient interaction between a refraction index grating
and light beams during simultaneous writing and thermal fixing of
a photorefractive hologram is investigated. With a diffusion- and
photovoltaic-dominated carrier transport mechanism and carrier thermal
activation (temperature dependent) considered in Fe:LiNbO3 crystal, from
the standpoint of field-material coupling, the theoretical thermal fixing
time and the space-charge field buildup, spatial distribution, and temperature
dependence are given numerically by combining the band transport
model with mobile ions with the coupled-wave equation
Design and development of a new feed -horn antenna
with low sidelobe levels is reported . The E-walls of this
antenna are fabricated with low -loss dielectric substrate ,
periodicallyloaded with thin conducting strips . The antenna
is found to be simulating the radiation characteristics of metallic
Corrugated horns . This can be an ideal substitute for metallic
Corrugated horns with added advantages like light -weight and low
production cost
The (Ba1-x Srx) (Nd1/2, Nb1/2) O3 ceramics have been prepared by the conventional
ceramic route for different values of x. Addition of a small amount of
CeO2(1 wt%) as a sintering aid increased the density of the samples. The structure
and microstructure of the sintered samples are studied by X-ray diffraction
and SEM methods. The dielectric properties of the samples are measured in the
microwave frequency region as a function of composition. The dielectric constant
decreases as x increases. The coefficient of thermal variation of resonant
frequency decreases as the Sr content increases and goes to the negative side.
The dielectric properties of (Ba1-x Srx) (Nd1/2, Nb1/2) O3 are in the range suitable
for application as dielectric resonators in microwave circuits
Pazhoor Bijumon, Varghese; Mohanan, P; Mailadil, Thomas Sebastian(The Japan Society of Applied Physics, 2002)
[+]
[-]
Abstract:
Microwave ceramic dielectric materials Ca5Nb2TiO12 and Ca5Ta2TiO12 have been prepared by a conventional solid-state
ceramic process. The structure was studied by X-ray diffraction and the dielectric properties were characterized at microwave
frequencies. The ceramics posses a relatively high dielectric constant, very low dielectric loss (Q5 x f > 30000GHz) and
small temperature variation of resonant frequency. These materials are potential candidates for dielectric resonator
applications in microwave integrated circuits. [DOI: 10. 1 143/JJAP.41.3834]
Dielectric ceramics based on solid solution phases of [RE1_x= REr]TiNb06, where REI_s = Nd, Pr, Sm and RE' = Dy, Gd and Y, were prepared by the conventional solid-state ceramic route for values of x. The ceramic samples are characterized by X-ray diffraction and microwave methods. Ceramics based on RE (Pr, Nd and Sm) belonging to aeschynite group shows positive value of Tf and those based on RE (Gd, Dy and Y) belonging to euxenite group show negative value of r f. The solid solution phases between the aeschynite and the euxenite group shows intermediate dielectric constant and r f values. The results indicate the possibility of tailoring the dielectric properties by varying the composition of the solid solution phases. The range of solid solubility of euxenite in aeschenite and aeschenite
in euxenite are different for different rare earth ions
Ceramic dielectric resonators in the BaO-RE2O3-TiO2 (RE = rare earth) system have been
prepared by the conventional solid state ceramic route. The dielectric properties have been
tailored by substitution of different rare earth oxides and by bismuth oxide addition. The
dielectric constants increased with Bi addition whereas the 0 decreased. The temperature
coefficient of the resonant frequency improved with bismuth addition
Microwave dielectric ceramics based on GdTiNb,-,.Ta,O6 and Sml _.,Y,TiTa06 have been prepared by conventional solid state
method . The GdTiTaO6 and SmTiTaO6 have aeschenite structure with positive rr and GdTiNbO6 and YTiTaO6 have euxenite
structure with negative rr. The rr of the ceramics has been tuned by preparing solid solution phases between the aeschynites and
euxenites for a possible zero rr material . It is observed that GdTiNbt_YTa.,O6 undergoes a phase transition from aeschynite to
euxenite when x=0.75 and in Sml-,YxTiTa06 for x= 0.73. The microwave dielectric properties change abruptly near the transition
region . The rr value approaches zero near the phase transition region while the samples have poor sinterability and poor quality
factor . The unloaded quality factor, dielectric constant and the sign of rr of the solid solution phases are found to depend on the
average ionic radius of the rare earth ion in RE ,-5RE',TiTaO6. The boundary of the euxenite-aeschynite phase transition occurs at
an average ( RE) ionic radius of 0.915 A in Sm,_, Y,.TiTaO6 solid solution phases
The microwave dielectric properties of ZnAl2O4 spinels were investigated and their properties
were tailored by adding different mole fractions of Ti02. The samples were synthesized using the mixed
oxide rout.e. The phase purity and crystal structure were identified using X-ray diffraction technique.
The sintered specimens were characterized in the microwave frequency range (3-13 GHz). The ZnA12O4
ceramics exhibited interesting dielectric properties (dielectric constant (e,.) = 8.5, unloaded quality factor
(Q.) = 4590 at 12.27 GHz and temperature coefficient of resonant frequency (Tf) = -79 ppm/°C).
Addition of Ti02 into the spinel improved its properties and the Tf approached zero for 0.83ZnAl2O4-
0.17TiO2• This temperature compensated composition has excellent microwave dielectric properties (Cr _
12.67, Q, = 9950 at 10.075 GHz) which can be exploited for microwave substrate applications
Qinghe, Mao; John, Lit W Y(Microwave and Optical Technology Letters, November 20, 2002)
[+]
[-]
Abstract:
The transient characteristics of an erbium-doped fiber
(F.DF) laser, which can switch between wavelengths. are investigated.
77te laser has a set of coupled linear cavities. The slow gain dynamics
of EDFs and the cross-gain saturation in the coupled cavities give rise
to delayed switching responses and relocation oscillations, which are
respertively measured to be l ins and 3.5 ms for the worst rase, and
which mar be decreased by increasing the pump power. Thus, the
switching speed of the laser may be higher than 100 Hz
Bijumon, P V; Sreedevi, Menon K; Suma,M N(Microwave and Optical Technology Letters, November 5, 2005)
[+]
[-]
Abstract:
rectangular low-density, high-permittivity dielectric
resona or antenna (DRA) excited by T-shaped microstrip feed offering a
2:1 VSWR bandwidth of -22% at 2.975 GHz is reported. The design
methoaology and experimental results of the antenna are discussed. The
excellent gain and radiation performance of the proposed antenna
project: it as a potential candidate for telecommunication applications
Shyam S,Pattnaik; Dhruba C,Panda; Devi,S(Microwave and Optical Technology Letters, September 20, 2002)
[+]
[-]
Abstract:
The mathematical formulation of empirically developed formulas Jirr the calculation of the resonant frequency of a thick-substrate
(h s 0.08151 A,,) microstrip antenna has been analyzed. With the
use qt' tunnel-based artificial neural networks (ANNs), the resonant frequency
of antennas with h satisfying the thick-substrate condition are
calculated and compared with the existing experimental results and also
with the simulation results obtained with the use of an IE3D software
package. The artificial neural network results are in very good agreement
with the experimental results