Abstract: | Invertase was immobilised on microporous montmorillonite K-10 via adsorption and covalent binding. The immobilised enzymes were tested for sucrose hydrolysis activity in a batch reactor. Km for immobilised systems was greater than free enzyme. The immobilised forms could be reused for 15 continuous cycles without any loss in activity. After 25 cycles, 85% initial activity was retained. A study on leaching of enzymes showed that 100% enzyme was retained even after 15 cycles of reuse. Leaching increased with reaction temperature. Covalent binding resisted leaching even at temperatures of 70 °C. |
URI: | http://dyuthi.cusat.ac.in/purl/2312 |
Files | Size |
---|---|
Dyuthi-SS80.pdf | (185.0Kb) |
Abstract: | The present work investigates on the applicability of metal promoted sulphated zirconia catalysts for the hydroxylation of phenol under mild conditions. The percentage conversion and product distribution was highly sensitive towards the reaction parameters like the catalyst composition, reaction temperature, H202/ phenol ratio and the solvent used. |
URI: | http://dyuthi.cusat.ac.in/purl/2218 |
Files | Size |
---|---|
Dyuthi-SS19.pdf | (643.1Kb) |
Abstract: | The Lewis acidity of yttrium and dysprosium exchanged zeolite Y and ZSM-5 has been determined by titration method using Hammett indicators. The acidity of the Y form increases with increase in concentration of the rare earth cation in the Y zeolite. It is independent of the amount of the rare earth ion for ZSM-5. The data have been correlated with the activity of these zeolites for the esterification of butanol using acetic acid. |
URI: | http://dyuthi.cusat.ac.in/purl/2310 |
Files | Size |
---|---|
Dyuthi-SS77.pdf | (173.7Kb) |
Abstract: | The present work undertakes the preparation and physico-chemical characterisation of iron promoted sulphated zirconia (SZ) with different amounts of iron loading and their application to Friedel-Crafts benzoylation of benzene, toluene and xylene under different experimental conditions, XRD and laser Raman techniques reveal the stabilisation of the tetragonal phase of zirconia and the existence of iron in highly dispersed form as Fe203 on the catalyst surface. The surface acidic properties were determined by ammonia temperature programmed desorption (TPD) and perylene adsorption, The results were supported by the TGA studies after adsorption of pyridine and 2,6-dimethylpyridine (2,6-DMP), Strong Lewis acid sites on the surface, which are evident from TPD and perylene adsorption studies. explain the high catalytic activity of the systems towards benzoylation. The experimental results provide evidence for the truly heterogeneous nature of the reaction. The studies also establish the resistance to deactivation in the metal incorporated sulphated systems. |
URI: | http://dyuthi.cusat.ac.in/purl/2279 |
Files | Size |
---|---|
Dyuthi-SS62.pdf | (696.8Kb) |
Abstract: | Iron, aluminium and mixed iron aluminium pillared clays have been prepared by partial hydrolysis method and doped with IO% Mo, V and Cr. The samples have been characterised by XRD, FTIR and surface area and pore Volume measurements. The surface acid site distribution has been determined by temperature programmed desorption of ammonia. Vanadia incorporated systems show maximum acidity. Benzylation of o-xylene has been done as probe reaction to test catalytic activity. Benzyl chloride is a superior benzylating agent compared to benzyl alcohol in activity and selectivity. Cent percent selectivity towards monobenzylated product is obtained in all the cases. Fe pillared systems exhibit maximum activity. The catalytic activities of the systems can be correlated with the amount of strong add sites. The effects of various reaction variables on the reaction have been studied. Presence of moisture has a diminishing effect on the reaction rate. |
URI: | http://dyuthi.cusat.ac.in/purl/2248 |
Files | Size |
---|---|
Dyuthi-SS41.pdf | (593.7Kb) |
Abstract: | The liquid-phase Friedel-Crafts acylation of toluene using benzoyl chloride as benzoylating agent has heen carried out over Nix, Mn(l-x)Fe2 O4 (x=O, 0.2, 0.4, 0.6, 0.8 and 1.0) type systems under different reaction conditions. It is observed that the systems with high 'x' values are effective for the conversion of BOC and the selective formation of 4-MBP. Selectivity for 4-MBP over MnFe2O4 is more than 90% under the optimized reaction conditions. Sites of moderate acidity is effective in calalyzing the benzoylation reaction. |
URI: | http://dyuthi.cusat.ac.in/purl/2210 |
Files | Size |
---|---|
Dyuthi-SS14.pdf | (504.4Kb) |
Abstract: | Kinetics of mercuric chloride catalysed solvolysis of benzyl chloride have been studied in water. 10% aq. ethanol, 10,20 and 30% aq. acetone and 20% aq. DMSO. The results confirm the operation of a mass law effect. |
URI: | http://dyuthi.cusat.ac.in/purl/2224 |
Files | Size |
---|---|
Dyuthi-SS28.pdf | (212.1Kb) |
Abstract: | A series of supported vanadia systems have been prepared by excess solvent technique using La203 and DY203 as supports. Physical characterization has been carried out using XRD, FTIR, TG studies, BET surface area measurement, pore volume analysis etc. Cyclohexanol decomposition has been used as a test reaction for evaluating the acid base properties of the supported system. The oxidative dehydrogenation of ethylbenzene has been employed as a chemical probe reaction to examine the catalytic activity. The active species correspond to amorphous and crystalline tetrahedral vanadyl units in the supported system. |
URI: | http://dyuthi.cusat.ac.in/purl/2211 |
Files | Size |
---|---|
Dyuthi-SS13.pdf | (624.7Kb) |
Abstract: | The thermal diffusivity of y-alumina is determined by the photoacoustic method. The method is calibrated by determining the thermal diffusivity of copper and aluminum. The effect of the chemisorbed hydroxyl groups or thermal diffusivity is studied by degassing the sample at different temperatures. |
URI: | http://dyuthi.cusat.ac.in/purl/2276 |
Files | Size |
---|---|
Dyuthi-SS37.pdf | (239.8Kb) |
Abstract: | The effect of the chemisorbed hydroxyl groups on the thermal diffusivity of gama alumina is determined by evaluating the thermal diffusivity at various degassing temperatures and by doping it with rare earth oxide using photoacoustic technique. The thermal diffusivity is found to decrease with the increase in degassing temperature as well as with the increase in the doping concentration of rare earth oxide. This decrease has been attributed to the loss of hydroxyl ion from the y-Al2O3. |
URI: | http://dyuthi.cusat.ac.in/purl/2656 |
Files | Size |
---|---|
Dyuthi-P0337.pdf | (665.8Kb) |
Abstract: | The heterogeneous photocatalytic degradation of methylorange over TiO2 is studied and is found to be cost effective. Effect of Zirconium metal incorporation over titania system is investigated. Photocatalytic degradation of methylorange using solar radiation is found to be highly economical when compared with the processes using artificial UV radiation, which require substantial electrical power input. The characterization of titania as well as modified zirconium metal doped titania systems are done using XRD, FTIR and EDAX measurements. The catalytic activities of different systems are also compared and is tried to correlate with the crystallite size and presence of dopant metal. |
URI: | http://dyuthi.cusat.ac.in/purl/2127 |
Files | Size |
---|---|
Photodegradation of methylorange...pdf | (127.3Kb) |
Abstract: | Lanthana modified sol-gel titania is prepared through particulate sol-gel route and the physico-chemical characterizations of the prepared systems were done using X-Ray diffration, EDX, BET surface area-pore volume measurements and TG-DTG analysis. Benzophenone was observed to be the sole product in the TiO2 photocatalyzed oxidation of benzhydrol in oxygen purged acetonitrile. The influence of various parameters, like irradiation time, amount of catalyst, concentration of the catalyst and other factors on the photocatalytic oxidation has been investigated. The proposed mechanism envisages the involvement of a superoxide radical anion. |
URI: | http://dyuthi.cusat.ac.in/purl/2258 |
Files | Size |
---|---|
Dyuthi-SS50.pdf | (293.0Kb) |
Abstract: | In situ polymerization of aniline is done inside the pillared clay matrix. The nonswellable pillared clay confined matrix allows efficient polymerization that leads to nanofibrous morphology. As a result high polymer order and crystallinity is attained and is evident from XRD patterns. The strong interaction between the clay layers and polyaniline (PANI) is understood from FTIR and DRS spectra. Additionally these analytical results suggest that the prepared PANI is in the doped state. The PANI/pillared clay nanocomposite formation gives additional thermal stability to the polymer backbone and is clear from the DTG curves. |
URI: | http://dyuthi.cusat.ac.in/xmlui/purl/1938 |
Files | Size |
---|---|
Polyaniline....pdf | (238.4Kb) |
Abstract: | Transition metal-loaded (3%) nanocrystalline sulfated titania (ST) powders are prepared using the sol–gel technique. Anatase is found as the active phase in all the samples. Sulfate ion impregnation decreases the crystallite size and stabilizes the anatase phase of TiO2. Acidity of the samples is found to increase by the incorporation of sulfate ion and also by the modification by transition metal ions. All the prepared catalysts are found stable up to 700 °C. |
URI: | http://dyuthi.cusat.ac.in/purl/2251 |
Files | Size |
---|---|
Dyuthi-SS46.pdf | (383.1Kb) |
Abstract: | The results of a detailed study of the propionylation of anisole over various medium and large pore zeolites such as H-ZSM-5, H-beta, H-Na-beta. H-mordenite. H-Y and H-RE- Y are presented and discussed. In addition, homogenous catalysts and amorphous Si02-Al2O3 are also included for comparison, The catalyst and process parameters are optimised to enhance the conversion of propionyl chloride(PC) and selectivity to 4-methoxypropiophenone(4-MOPP). |
URI: | http://dyuthi.cusat.ac.in/purl/2163 |
Files | Size |
---|---|
Dyuthi-SS07.pdf | (383.6Kb) |
Abstract: | The Setschenow parameter and thermodynamic parameters of transfer of 2- and 4- hydroxybenzoic acids from water to salt solutions have been reported. The data have been rationalised by considering the structure breaking effects of the ions of the salts, the localized hydrolysis model, the internal pressure theory and the theory of water structure due to Symons. |
URI: | http://dyuthi.cusat.ac.in/purl/2231 |
Files | Size |
---|---|
Dyuthi-SS35.pdf | (214.4Kb) |
Abstract: | The Setschenow parameter and thermodynamic parameters of transfer of 2-, 3-, and 4-methylbenzoic acids from water to salt solutions have been reported. The data have been rationalized by considering the structure breaking effects of the ions of the salts, the localized hydrolysis model, and the internal pressure theory. |
URI: | http://dyuthi.cusat.ac.in/purl/2233 |
Files | Size |
---|---|
Dyuthi-SS38.pdf | (142.8Kb) |
Abstract: | The Setschenow parameter and thermodynamic parameters of transfer of 2-, 3- and 4-fluorobenzoic acid from water to salt solution are reported. The data have been rationalized by considering the structure breaking effects of the ions of the salts, the localized hydrolysis model and the internal pressure theory. |
URI: | http://dyuthi.cusat.ac.in/purl/2230 |
Files | Size |
---|---|
Dyuthi-SS33.pdf | (165.8Kb) |
Abstract: | Kinetics of mercuric chloride catalysed solvolysis of l-butyl chloride, benzyl chloride. p-methylbenzyl chloride, l-phenylethyl chloride and triethylcarbinyl chloride have been studied in aq. DMSO, aq. acetonitrile and aq. ethanol. The kinetic data fit a second order rate equation in aq. DMSO. The calculated values of the second order rate coefficients increase in the case of aq. acetonitrile and aq. ethanol. The order in catalyst in 95%(v/v) aq. DMSO is less than unity. |
URI: | http://dyuthi.cusat.ac.in/purl/2223 |
Files | Size |
---|---|
Dyuthi-SS27.pdf | (155.0Kb) |
Abstract: | Various compositions of chromium manganese ferrospinels were tested as catalysts for the vapour phase alkylation of aniline with methanol. The samples were prepared by room temperature co-precipitation technique and characterized by various physico-chemical methods. The acidity–basicity determination revealed that the samples possess greater amount of basic sites than acidic sites. All the ferrite samples proved to be selective and active for N-monoalkylation of aniline leading to N-methyl aniline; Cr0.6Mn0.4Fe2O4, Cr0.8Mn0.2Fe2O4 and CrFe2O4 exhibited cent percent selectivity for N-methyl aniline. Neither C-alkylated products nor any other side products were detected for all catalyst samples. The catalytic activity of the samples studied in this reaction is related to their acid–base properties and also on the cation distribution. Under the optimized reaction conditions all the systems showed constant activity for a long duration. |
URI: | http://dyuthi.cusat.ac.in/purl/2252 |
Files | Size |
---|---|
Dyuthi-SS47.pdf | (198.8Kb) |
Dyuthi Digital Repository Copyright © 2007-2011 Cochin University of Science and Technology. Items in Dyuthi are protected by copyright, with all rights reserved, unless otherwise indicated.