Polytetrafluoroethylene (PTFE) composites
filled with Sr2Ce2Ti5O16 ceramic were prepared by a powder
processing technique. The structures and microstructures
of the composites were investigated by X-ray diffraction
and scanning electron microscopy techniques. Differential
scanning calorimetry showed that the ceramic filler
had no effect on the melting point of the PTFE. The effect
of the Sr2Ce2Ti5O16 ceramic content [0–0.6 volume fraction
(vf)] on the thermal conductivity, coefficient of thermal
expansion (CTE), specific heat capacity, and thermal diffusivity
were investigated. As the vf of the Sr2Ce2Ti5O16 ceramic increased, the thermal conductivity of the specimen
increased, and the CTE decreased. The thermal conductivity
and thermal expansion of the PTFE/Sr2Ce2Ti5O16
composites were improved to 1.7 W m21 8C21 and 34
ppm/8C, respectively for 0.6 vf of the ceramics. The experimental
thermal conductivity and CTE were compared
with different theoretical models.
Ramachandran, A; Sankar, T V(Society of Chemical Industry, November 26, 2004)
[+]
[-]
Abstract:
The characteristics and stability of natural actomyosin (NAM) from rohu (Labeo rohita), catla
(Catla catla) and mrigal (Cirrhinus mrigala) were investigated. The total extractable actomyosin (AM)
was higher (7.60mgml−1) in the case of rohu compared with that from catla and mrigal (5mgml−1).
Although the specific AM ATPase activity was similar (0.43–0.5 μmolPmin−1 mgP−1) among the three
species, the total ATPase activity was lower in mrigal (25 μmol g−1 meat) compared with the other species
(37 μmol g−1 meat). The inactivation rate constants (kd) of AM Ca ATPase activity showed differences in
the stabilities of actomyosin among these fish, the actomyosin from catla being least stable. The NAM
from these species was stable up to 20 ◦C at pH 7.0. Catla AM became unstable at 30 ◦C, while rohu and
mrigal AM could withstand up to 45 ◦C. The thermal denaturation with respect to solubility, turbidity,
ATPase activity, sulphhydryl group and surface hydrophobicity showed noticeable changes at around
these temperatures
The thermal transport properties—thermal diffusivity, thermal conductivity and specific heat
capacity—of potassium selenate crystal have been measured through the successive phase
transitions, following the photo-pyroelectric thermal wave technique. The variation of thermal
conductivity with temperature through the incommensurate (IC) phase of this crystal is
measured. The enhancement in thermal conductivity in the IC phase is explained in terms of
heat conduction by phase modes, and the maxima in thermal conductivity during transitions is
due to enhancement in the phonon mean free path and the corresponding reduction in phonon
scattering. The anisotropy in thermal conductivity and its variation with temperature are
reported. The variation of the specific heat with temperature through the high temperature
structural transition at 745 K is measured, following the differential scanning calorimetric
method. By combining the results of photo-pyroelectric thermal wave methods and differential
scanning calorimetry, the variation of the specific heat capacity with temperature through all the
four phases of K2SeO4 is reported. The results are discussed in terms of phonon mode softening
during transitions and phonon scattering by phase modes in the IC phase.
Manjusha, M V; Dr. Jacob, Philip(Cochin University of Science and Technology, May , 2008)
[+]
[-]
Abstract:
Photothermal spectroscopy is a group of high sensitivity methods used to measure optical absorption and thermal characteristics of a sample.The basis of photothermal spectroscopy is a photo-induced change in the thermal state of the sample.Light energy absorbed and not lost by subsequent emission results in sample heating.This heating results in a temperature change as well as changes in thermodynamic parameters of the sample which are related to temperature.Measurements of the temperature,pressure,or density changes that occur due to optical absorption are ultimately the basis for the photothermal spectroscopic methods.This is a more direct measure of optical absorption than optical transmission based spectroscopies.Sample heating is a direct consequence of optical absorption and so photothermal spectroscopy signals are directly dependent on light absorption.Scattering and reflection losses do not produce photothermal signals.Subsequently,photothermal spectroscopy more accurately measures optical absorption in scattering solutions,in solids,and at interfaces.This aspect makes it particularly attractive for application to surface and solid absorption studies,and studies in scattering media.
Description:
Department of Instrumentation,
Cochin University of Science and Technology
Mohanan, P V; Dr.Chandrasekaran,M(Cochin University of Science And Technology, August , 1995)
[+]
[-]
Abstract:
Microbial enzymes are in great demand owing to their
importance in several industries such as brewing, baking,
leather, laundry detergent, dairy. starch processing and
textiles besides pharmaceuticals. About 80% of the enzymes
produced through fermentation and sold in the industrial scale
are hydrolytic enzymes. Due to recognition of new and new
applications, an intensive screening of different kinds of
enzymes with novel properties, from various microorganisms, is
being pursued all over the world. Bacillus sp are largely known to produce a-amylase, among the different groups of microoganisms, at industrial level. They are known to produce both saccharifying and liquefying a-amylases (Fukumoto 1963; walker and Campbell, 1967a). which are distinguishable by their mechanisms of starch degradation by the fact that the saccharifying asamylases produce an increase in reducing power about twice that of the liquefying enzyme (Fukumoto, 1963; Pazur and Okada, 1966). Under this circumstances, the present study was
undertaken, with a View to utilise a fast growing B.coagu1ans
isolated from soil, for production of thermostable and
alkaline oz-amylase under different fermentation processes
Description:
Department of Biotechnology, Cochin University of Science And Technology
Sugunan, S; Ramankutty, C G(American Chemical Society, 1995)
[+]
[-]
Abstract:
The enthalpies of formation of charge-transfer complexes of benzene, chlorobenzene, and 1,3-dichlorobenzene
as donors with 7,7,8,8-tetracyanoquinodimethane as acceptor were determined. The thermochemical
data show an increased stability of charge-transfer complexes of donors with permanent dipole moment.
The results confirm the importance of electrostatic forces in bonding and stabilizing weak complexes.
The approximate formation constants of the complexes are also reported.
Sugunan, S(Indian Journal of Chemistry, September , 1984)
[+]
[-]
Abstract:
The Setschenow parameters of solubility in salt solutions and the
thermodynamic parameters (25·C) of transfer from aqueous
solution to aqueous salt solutions for 2-nitrobenzoic acid and 3-nitrobenzoic
acid have been reported. The data have been
rationalized on the basis of the localized hydrolysis model and the
structure breaking action of ions of the electrolytes.
Sugunan, S; Thomas, B(American Chemical Society, 1995)
[+]
[-]
Abstract:
The Setschenow parameter and thermodynamic parameters of transfer of 2- and 4-aminobenzoic acids
from water to salt solutions have been reported. The results are discussed in terms of the structure- breaking
effects of the ions of the salts, the localized hydrolysis model, and the internal pressure theory.
Sugunan, S; Benny, Thomas(Indian Journal of Chemistry, July , 1993)
[+]
[-]
Abstract:
The Setschenow parameter and thermodynamic parameters of transfer of a number of monosubstituted
benzoic acids from water to different salt solutions have been reported. The data have been rationalized by
considering the structure breaking effects of the ions of the salts, the localised hydrolysis model, the internal
pressure theory and Symons' theory of water structure.
Hareeshkumar, P V; Dr.Basil, Mathew(Cochin University of Science And Technology, January , 1992)
[+]
[-]
Abstract:
The Arabian Sea is an area of complex air-sea interaction
processes with seasonal reversing monsoons. The associated
thermohaline variability in the upper layers appears to
control the large scale monsoon flow which is not yet
completely understood.
The variability in the thermohaline fields is known to
occur in temporal domain ranging from intra-diurnal to
inter-annual time scales and on spatial domains of few tens of
kilometers to few thousands of kilometers. In the Arabian Sea
though the surface temperature was routinely measured by both
conventional measurements and satellites, the corresponding
information on the subsurface thermohaline field is very
sparse due to the lack cw adequate measurements. In such
cases the numerical models offer promise in providing
information on the subsurface features given an initial
thermohaline field and surface heat flux boundary conditions.
This thesis is an outcome of investigations carried out
on the various aspects of the thermohaline variability on
different time scales. In addition to the description of the
mean annual cycle. the one dimensional numerical models of
Miller (1976) and Price et a1 (1986) are utilised to simulate
the observed mixed layer characteristics at selected locations
in the Arabian Sea on time scales ranging from intra-diurnal
to synoptic scales under variable atmospheric forcing.
Anju, K. Augustine; Dr.Kailasnath, M; Prof. V P N Nampoori(Cochin University of Science and Technology, June 23, 2015)
[+]
[-]
Abstract:
In general, linear- optic, thermo- optic and nonlinear- optical studies
on CdSe QDs based nano
uids and their special applications in solar
cells and random lasers have been studied in this thesis. Photo acous-
tic and thermal lens studies are the two characterization methods used
for thermo- optic studies whereas Z- scan method is used for nonlinear-
optical charecterization. In all these cases we have selected CdSe QDs
based nano
uid as potential photonic material and studied the e ect of
metal NPs on its properties.
Linear optical studies on these materials have been done using vari-
ous characterization methods and photo induced studies is one of them.
Thermal lens studies on these materials give information about heat
transport properties of these materials and their suitability for applica-
tions such as coolant and insulators. Photo acoustic studies shows the
e ect of light on the absorption energy levels of the materials. We have
also observed that these materials can be used as optical limiters in the
eld of nonlinear optics. Special applications of these materials have
been studied in the eld of solar cell such as QDSSCs, where CdSe QDs
act as the sensitizing materials for light harvesting. Random lasers have
many applications in the eld of laser technology, in which CdSe QDs
act as scattering media for the gain.
Santhosh, B; Dr.Nandakumar, C G(Cochin University of Science & Technology, December , 2010)
[+]
[-]
Abstract:
Three dimensional (3D) composites are strong contenders for the structural applications in situations like aerospace,aircraft and automotive industries where multidirectional thermal and mechanical stresses exist. The presence of reinforcement along the thickness direction in 3D composites,increases the through the thickness stiffness and strength properties.The 3D preforms can be manufactured with numerous complex architecture variations to meet the needs of specific applications.For hot structure applications Carbon-Carbon(C-C) composites are generally used,whose property variation with respect to temperature is essential for carrying out the design of hot structures.The thermomechanical behavior of 3D composites is not fully understood and reported.The methodology to find the thermomechanical properties using analytical modelling of 3D woven,3D 4-axes braided and 3D 5-axes braided composites from Representative Unit Cells(RUC's) based on constitutive equations for 3D composites has been dealt in the present study.High Temperature Unidirectional (UD) Carbon-Carbon material properties have been evaluated using analytical methods,viz.,Composite cylinder assemblage Model and Method of Cells based on experiments carried out on Carbon-Carbon fabric composite for a temparature range of 300 degreeK to 2800degreeK.These properties have been used for evaluating the 3D composite properties.From among the existing methods of solution sequences for 3D composites,"3D composite Strength Model" has been identified as the most suitable method.For thegeneration of material properies of RUC's od 3D composites,software has been developed using MATLAB.Correlaton of the analytically determined properties with test results available in literature has been established.Parametric studies on the variation of all the thermomechanical constants for different 3D performs of Carbon-Carbon material have been studied and selection criteria have been formulated for their applications for the hot structures.Procedure for the structural design of hot structures made of 3D Carbon-Carbon composites has been established through the numerical investigations on a Nosecap.Nonlinear transient thermal and nonlinear transient thermo-structural analysis on the Nosecap have been carried out using finite element software NASTRAN.Failure indices have been established for the identified performs,identification of suitable 3D composite based on parametric studies on strength properties and recommendation of this material for Nosecap of RLV based on structural performance have been carried out in this Study.Based on the 3D failure theory the best perform for the Nosecap has been identified as 4-axis 15degree braided composite.
Description:
Dept.of Ship Technology,Cochin University of Science and Technology
Unnikrishnan, K P; Jayan,Thomas; Nampoori, V P N; Vallabhan, C P G(Elsevier, April 1, 2002)
[+]
[-]
Abstract:
Third order nonlinear susceptibility χ(3) and second hyperpolarizability (γ) of a bis-naphthalocyanine viz. europium naphthalocyanines, Eu(Nc)2, were measured in dimethyl formamide solution using degenerate four wave mixing at 532 nm under nanosecond pulse excitation. Effective nonlinear absorption coefficient, βeff and imaginary part of nonlinear susceptibility, Im(χ(3)) were obtained using open aperture /Z-scan technique at the same wavelength. Optical limiting property of the sample was also investigated. The role of excited state absorption in deciding the nonlinear properties of this material is discussed.
This manuscript describes the first example of silver ion complex of a dendritic tetranitrile ligand catalyzed
one-pot three component Mannich reaction and 1,5-benzodiazepine synthesis. The catalyst can be separated from the
products by a change in the solvent. The catalyst is reusable.
In this paper we try to fit a threshold autoregressive (TAR) model to time series data of monthly coconut oil prices at Cochin market. The procedure proposed by Tsay [7] for fitting the TAR model is briefly presented. The fitted model is compared with a simple autoregressive (AR) model. The results are in favour of TAR process. Thus the monthly coconut oil prices exhibit a type of non-linearity which can be accounted for by a threshold model.